When Frequency is set to Dual-Band, users can check this option to
enable Band Steering on the Access Point, this will help redirecting clients
to a radio band accordingly for efficient use and to benefit from the
maximum throughput supported by the client.
This feature will help Wi-Fi client to roam to other APs within same
Network.
Parameters of RSSI Threshold and Client Access Threshold parameters
will show up only when Client Steering is enabled.
Configures interval between beacon transmissions/broadcasts.
The Beacon signals help to keep the network synchronized and provide
main information about the network such as SSID, Timestamp…
Using High Beacon Interval: AP will be sending beacon
broadcast less frequently. This will help to get better throughput,
thus better speed/performance. It also helps to save Wi-Fi clients
energy consumption.
Using Low Beacon Interval: AP will be sending beacon
broadcast more frequently. This can help in environments with
weak signal areas; sending more frequently beacons will increase
chances to be received by Wi-Fi clients with weak signal.
Notes:
1. When AP enables several SSIDs with different interval values,
the max value will take effect.
2. When AP enables less than 3 SSIDs, the interval value which
will be effective are the values from 40 to 500.
3. When AP enables more than 2 but less than 9 SSIDs, the
interval value which will be effective are the values from 100 to
500.
4. When AP enables more than 8 SSIDs, the interval value which
will be effective are the values from 200 to 500.
5. Mesh feature will take up a share when it is enabled.
To Next Page
Loading...
Need help?
General
