GRAPHTEC CE7000-130AP - Page 13

C-3
3.3 Setting the Origin Point .............................................. 3 -7
When coordinate axes rotation are set ...........................................3-8
When coordinate axes are rotated after origin point is set ............................3-8
Setting origin point when HP-GL is set ...........................................3-9
3.4 Setting the Cutting Direction ........................................3 -10
3.5 Stop Cutting ......................................................3 -12
Pause and resume cutting ....................................................3 -12
Stop cutting ...............................................................3 -13
Chapter 4: Convenient Functions
4.1 Settings for Cutting .................................................4-2
Setting cutting area ..........................................................4-2
Setting cutting width (EXPAND) ................................................4-4
Setting length of the page .....................................................4-5
Setting the number of pre feeds ................................................4 -7
Setting paper Ready time .....................................................4-8
Setting the space rear ........................................................4-9
4.2 Copy (Duplicate Cutting) ............................................ 4 -11
When media change mode is OFF ............................................4 -11
When media change mode is ON .............................................4 -14
4.3 Panel Cutting .....................................................4 -16
4.4 Cross Cut Force ...................................................4 -18
Chapter 5: Manual Position Adjust
5.1 Overview of Axis Adjustment .........................................5-2
Alignment mark .............................................................5-2
Example of axis adjustment ....................................................5-2
5.2 Adjusting Coordinate Axes ...........................................5-3
Starting point setting .........................................................5-3
Chapter 6: Cut function settings
6.1 Set F Command of Cutting (F_CUT) ....................................6-2
6.2 Setting a Time Out ..................................................6-3
6.3 Setting a Separator .................................................6-5
GP-GL separator ............................................................6-5
HP-GL separator ............................................................6-6
6.4 Ofine Output from USB Memory .....................................6-8
6.5 Cross Cut Settings .................................................6 -10
6.6 Setting Rear Margin ................................................6 -12
6.7 Setting the Number of Pre Feeds .....................................6 -14
6.8 Setting Paper Exposure Time ........................................ 6 -16