C-4
Chapter 7: Setting Regarding Cutting Quality
7.1 Cutting the Corner of Thick Media Sharp ...............................7-2
Outline of tangential mode .....................................................7-2
Setting the tangential mode ....................................................7-3
Setting the length of overcut ...................................................7-4
Setting of the Initial Down Force ................................................7-6
7.2 Setting the Step Pass ...............................................7-8
7.3 Setting the Offset Angle ............................................ 7-10
7.4 Setting the Distance Adjust ......................................... 7-12
7.5 Setting Cut Line Pattern ............................................ 7-15
7.6 Setting Initial Blade Control Position Adjust ........................... 7-19
7.7 Setting the OFFSET FORCE .........................................7-21
7.8 Setting Adjustment Between the Tools ................................7-22
7.9 Cross cut the roll paper .............................................7-25
Cut Width .................................................................7-26
Manually cross-cut ..........................................................7-26
Chapter 8: Settings Regarding Cutting Time
8.1 Sorting the Cutting Data .............................................8-2
8.2 Perform Automatic Pre Feed When Cut Data is Received ..................8-4
8.3 Perform Automatic Pre Feed When Media is Set (Initial Feed) ..............8-6
8.4 Setting Feed Speed for Pre Feed ...................................... 8-7
8.5 Setting the Moving Speed ............................................8-9
8.6 Setting the Tool Up Move ........................................... 8 -11
8.7 Setting the Tool Up Height ..........................................8 -13
Chapter 9: Setting Regarding Interface
9.1 Setting Interface ....................................................9-2
USB interface ...............................................................9-2
Network (LAN) interface ......................................................9-2
RS-232C interface ...........................................................9-3
9.2 Clearing the Buffer Memory ..........................................9-4
9.3 I/F (LAN) ..........................................................9-5
Setting the DHCP ..........................................................9-5
Set IP address, subnet mask, gateway ..........................................9 -7
9.4 Connecting with RS-232C ...........................................9 -10
Switching the setting number you want to use ...................................9 -10
Changing/storing the RS-232C setting .........................................9 -11
9.5 User selection settings .............................................9 -14
Setting user selection ......................................................9 -14
Switching the user selection setting ...........................................9 -15
To Next Page
Loading...
