C-5
Chapter 10: Settings Regarding Operation Environment
Related to menu display .....................................................10- 2
Display language setting (LANGUAGE SELECTION) ..............................10 -2
Display Length Unit Setting (LENGTH UNIT) ....................................10 -3
Related to sensor ...........................................................10 - 4
Enabling/Disabling the media sensors (MEDIA SENSOR) ..........................10 -4
Enabling/Disabling the push roller sensors (PUSH ROLLER SENSOR) ................10 - 5
Related to plotter environment .................................................10 -7
Fan suction setting (FAN POWER) ............................................10 -7
Enabling/Disabling the beep setting (BEEP FOR KEY OPERATION) .................10 -8
Low Movement Speed Setting by POSITION key (POSI. KEY SPEED + SLOW KEY) ....10-9
High Movement Speed Setting by POSITION key (POSI. KEY SPEED). . . . . . . . . . . . . . .10 -10
Pause key select setting (Selecting PAUSE key) .................................10 -11
LCD contrast setting (LCD contrast) ..........................................10 -12
Chapter 11: Settings of Controls from Computer
Related to command processing ...............................................11- 2
Setting the command (COMMAND) ...........................................11- 2
Priority of tool condition selection (CONDITION PRIORITY) ........................11- 3
Related to GP-GL command ..................................................11- 4
Setting the step size (GP-GL STEP SIZE) .......................................11- 4
Enabling/Disabling the ' : ' and ' ; ' commands (COMMAND ' : ', ' ; ') ..................11- 5
Moving the pen while raised or lowered in
Response to the 'W' command (COMMAND 'W') .................................11- 6
Related to HP-GL command .................................................. 11-7
Model ID response (HP-GL MODEL EMULATED) ................................11-7
Circle-command resolution setting (CIRCLE RESOLUTION) ........................11- 8
Chapter 12: Maintenance
12.1 Daily Maintenance .................................................12- 2
Daily maintenance ..........................................................12- 2
Storing the plotter ..........................................................12-2
12.2 Replacing Cutter Blade .............................................12-3
12.3 Cleaning the Cutter Pen ............................................12- 5
12.4 Cutter Plunger Exchange ...........................................12- 6
12.5 Setting the Alarm for Degree of Wear (BLADE WEAR ALARM) ............ 12-7
Chapter 13: Troubleshooting
13.1 Troubleshooting ...................................................13-2
When the plotter does not operate after turning the power on ........................13 - 2
When it does not work right ...................................................13 - 3
When the Cutting Result is Not Good ...........................................13 -5
Error Messages in GP-GL Command Mode ......................................13 - 6
Error Messages in HP-GL Command Mode ......................................13 -7
ARMS Error Messages ......................................................13 -9
Other Error Messages ......................................................13 -10
Caution Message ..........................................................13 -12
13.2 Printing the Setting of the Plotter ....................................13 -13
13.3 Creating Test Pattern ..............................................13 -15
To Next Page
Loading...
