iii
Be sure that the plotter is grounded.
• If the plotter is not grounded, the operator could
suffer an electrical shock in case of current leak-
age.
Do not disassemble, repair, or remodel the plotter.
• Such action may cause electrical shock or a fire
hazard due to current leakage.
• Contact with the high-voltage parts within the
plotter may cause electrical shock.
• If the plotter requires repair, contact your sales
representative or nearest Graphtec vendor.
Do not use the plotter in a location where it will
be exposed to water, rain or snow.
• Such location may cause electrical shock or a fire
hazard due to current leakage.
During a plotting or cutting operation, do not
touch the writing panel, carriage, and other
moving parts.
• Such action may cause human injury.
Even when the plotter is stopped, it may sud-
denly start operating if it receives data, so be
sure to keep your hands, hair, and so forth away
from the vicinity of the plotter’s writing panel
and moving parts such as the pen carriage.
• Such action may cause human injury.
Do not connect the plotter to a non-rated power
supply.
• Use of a different supply voltage may result in
electrical shock or a fire hazard due to current
leakage.
If the plotter generates smoke, is too hot, emits
a strange odor, or otherwise functions abnor-
mally, do not continue using it. Turn off its power
and unplug its power cord from the
electrical socket.
• Use of the plotter in such status may
result in a fire hazard or electrical shock.
• After confirming that smoke is no longer
being generated, contact
your sales representative
or nearest Graphtec ven-
dor to request repair.
• Never try to perform repair
yourself. Repair work by
inexperienced personnel
is extremely dangerous.
Safety Precautions
WARNING
Specified
rating
Use prohibited
No touching
Keep away
No disassembly
Ground the
Plotter
Avoid water
Beware of electrical shock
Prohibited
To Next Page
Loading...
