iv
Do not allow dust or metallic matter to adhere
to the power plug.
• A dirty power plug may result in electrical shock
or a fire hazard due to current leakage.
Avoid contact
Safety Precautions (Continued)
WARNING
Do not use the power cord if it is damaged.
• Use of a damaged cord may result in electrical
shock or a fire hazard due to current leakage.
• Replace the power cord with a new one.
Avoid direct contact with the cutter blade.
• Touching the blade with your bare hand may
cause injury.
• During a cutting operation, keep away from the
cutter blade.
CAUTION
Do not use or store the plotter in a location
exposed to direct sunlight or the direct draft of
an air conditioner or heater.
• Such location may impair the performance of the
plotter.
Do not place any receptacle containing water
or other fluid on top of the plotter.
• Fluid falling inside the plotter may cause electri-
cal shock or a fire hazard due to current leakage.
Do not use or store the plotter in an excessively
dusty or humid location.
• Such location may impair the performance of the
plotter.
Do not install, use, or store the plotter in a loca-
tion subject to excessive mechanical vibration
or electrical noise.
• Such location may impair the performance of the
plotter.
Beware of electrical shock
Prohibited
Unplug the power
cord from the socket
Avoid water
Beware of electrical shock Prohibited
Prohibited
Prohibited
To Next Page
Loading...
