APS-7000 Series User Manual
120
10. Go to the Fset setting set the frequency of the
step. Not applicable for Trans1 and Trans2.
45.00 ~ 500.0Hz (1000Hz optional)
11. Go to the Trig Out setting and set the state of
the trigger out pin at the start of each step.
12. Lastly, go to the Repeat parameter select the
number of times the simulation will repeat the
Normal1-Trans1-Abnormal-Trans2-Normal2
sequence of steps. A value of 0 will set the
number of repetitions to infinite.
To Next Page
Loading...
