GW Instek APS-7000 Series User Manual

APS-7000 Series User Manual
184
Model
APS-7050
APS-7100
APS-7200
APS-7300
General
Remote output signal
Pass, Fail, Test-in Process, Trigger in, Trigger out,
OUT ON/OFF
Trigger Out
Maximum low level output = 0.8V
Minimum high level output = 2V
Maximum source current = 8mA.
Trigger In
Maximum low level input voltage = 0.8V
Minimum high level input voltage = 2.0V
Maximum sink current = 8mA.
Sync output signal
Output Signal 10 V, BNC Type
Number of Preset
10 (0~9 numeric keys)
Protection
OCP, OPP, OTP and Alarm
Environmental Conditions
Operating
temperature range
0 ~ +40 C
Storage temperature
range
-10 ~ +70 C
Operating humidity
range
20 ~ 80% RH (no condensation)
Storage humidity
range
80% RH or less (no condensation)
LCD Display
4.3 inch, 480 (RGB) x 272
Dimensions (mm)
W
430
430
430
430
H
88
88
312
400
D
400
560
650
650
Weight
24Kg
38Kg
90Kg
128Kg
Sequence/Simulation Function
Number of Memories
10 (0~9 numeric keys)
Number of Steps
255 max. (for 1 sequence)
Step Time Setting Range
*8
0.01 ~ 999.99 S
Operation within Step
Constant, Keep, Linear Sweep
Parameters
Ouptut Range, Frequency, Waveform (sine wave
only), On Phase, Off Phase, Term
Jump Count (0 ~255), Jump-to, Branch 1, Branch
2, Trigger Output
Sequence Control
Start, Stop, Hold, Continue, Branch 1, Branch 2
Interface
Standard
USB Host, LAN
USB Host, USB-CDC,
LAN
Optional
GPIB (APS-001)
RS232/ USB CDC(APS-
002)
GPIB (APS-001)
RS232 (APS-007)

GW Instek APS-7000 Series Specifications

General

Brand	GW Instek
Model	APS-7000 Series
Category	AC Power Distribution
Language	English