MEASUREMENT
79
Edit program
This section assumes that the panel setting is already defined and
saved (step 1 and 2 in the previous page).
Panel operation
1. Press the Program key. The
display changes into
program edit mode.
Program
2. Press F1 (Edit/Play) to
select the Edit side.
Edit
Play
F 1
3. Press F2 (Step). Use the
Variable knob to select the
step that needs to be edited.
The cursor on the display
moves accordingly.
Step
01.
F 2
4. Press F3 (Item) repeatedly to
select the three parameters
for a step: panel setup,
menu (Cursor or Automatic
measurement), and time.
Item
Menu
F 3
To Next Page
Loading...
