FAQ
161
FAQ
•
I pressed the Power (On/Standby) key on the front panel but nothing
happens.
•
I connected the signal but it does not appear on the display.
•
I want to remove the (Measurement result / FFT result / Help
contents) from the display.
•
The waveform does not update (frozen).
•
The probe waveform is distorted.
•
Auto Set does not catch the signal well.
•
I want to clean up the cluttered panel settings.
•
The display image printout is too dark on the background.
•
I want to install the optional battery pack.
I put the battery pack in but it is not working.
•
The date and time setting are not correct.
•
USB does not work.
•
The accuracy does not match the specification.
I pressed the Power (On/Standby) key on the front panel
but nothing happens.
Make sure you turned On the rear panel Power switch. For power
up sequence, see page23.
I connected the signal but it does not appear on the display.
Make sure you have activated the channel by pressing the Channel
key (the LED turns On).
To Next Page
Loading...
