H3C S5500-EI - Page 214

195
Figure 55 Network diagram
Device Interface IP address Device Interface IP address
Switch A Vlan-int100 192.168.1.1/24 Switch D Vlan-int104 10.110.4.2/24
Vlan-int101 10.110.1.1
/
24 Vlan-int108 10.110.7.1
/
24
Switch B Vlan-int200 192.168.2.1/24 Vlan-int107 10.110.8.1
/
24
Vlan-int101 10.110.1.2/24 Switch E Vlan-int400 192.168.4.1/24
Vlan-int103 10.110.2.1
/
24 Vlan-int105 10.110.5.2
/
24
Vlan-int102 10.110.3.1
/
24 Vlan-int108 10.110.7.2
/
24
Switch C Vlan-int300 192.168.3.1/24 Switch F Vlan-int109 10.110.9.1/24
Vlan-int104 10.110.4.1
/
24 Vlan-int107 10.110.8.2
/
24
Vlan-int105 10.110.5.1
/
24 Vlan-int102 10.110.3.2
/
24
Vlan-int103 10.110.2.2/24 Switch G Vlan-int500 192.168.5.1/24
Vlan-int106 10.110.6.1
/
24 Vlan-int109 10.110.9.2
/
24
Switch H Vlan-int110 10.110.10.1
/
24 Source 1 — 192.168.2.10/24
Vlan-int106 10.110.6.2/24 Source 2 — 192.168.3.10/24
Switch I Vlan-int600 192.168.6.1/24 Source 3 — 192.168.5.10/24
Vlan-int110 10.110.10.2
/
24
Configuration procedure
1. Configure the IP address and subnet mask for each interface as per Figure 55. (Details not shown.)
2. Configure OSPF on the switches in the PIM-SM domain to make sure they are interoperable at the
network layer. (Details not shown.)
3. Enable IP multicast routing and administrative scoping, and enable IGMP and PIM-SM:
Vlan-int105
Vl
a
n-
i
n
t103
Vl
a
n-int30
0
V
lan-
i
n
t105
Vl
an
-
i
nt6
00
Vl
an-
int103