H3C S5500-EI - Page 259

240
An MSDP peering relationship is set up between Switch A and Switch C and between Switch C and
Switch D.
Source 1 sends multicast data to multicast groups 225.1.1.0/30 and 226.1.1.0/30, and Source 2 sends
multicast data to multicast group 227.1.1.0/30.
Configure SA message filtering rules so that receivers Host A and Host B can receive only the multicast
data addressed to multicast groups 225.1.1.0/30 and 226.1.1.0/30, and Host can receive only the
multicast data addressed to multicast groups 226.1.1.0/30 and 227.1.1.0/30.
Figure 65 Network diagram
Device Interface IP address Device Interface IP address
Source 1 — 10.110.3.100/24 Switch C Vlan-int300 10.110.4.1/24
Source 2 — 10.110.6.100/24 Vlan-int104 10.110.5.1/24
Switch A Vlan-int100 10.110.1.1/24 Vlan-int101 192.168.1.2/24
Vlan-int102 10.110.2.1/24 Vlan-int103 192.168.2.2/24
Vlan-int101 192.168.1.1/24 Loop0 2.2.2.2/32
Loop0 1.1.1.1/32 Switch D Vlan-int400 10.110.6.1/24
Switch B Vlan-int200 10.110.3.1/24 Vlan-int500 10.110.7.1/24
Vlan-int102 10.110.2.2/24 Vlan-int104 10.110.5.2/24
Vlan-int103 192.168.2.1/24 Loop0 3.3.3.3/32
Configuration Procedure
1. Configure the IP address and subnet mask for each interface as per Figure 65. (Details not shown.)
2. Configure OSPF on the switches to make sure the switches are interoperable at the network-layer,
and they can dynamically update their routing information. (Details not shown.)
3. Enable IP multicast routing, IGMP and PIM-SM, and configure a PIM domain border:
# On Switch A, enable IP multicast routing, enable IGMP on the host-side interface,
VLAN-interface 100, and enable PIM-SM on each interface.
MSDP peers
PIM-SM 1 PIM-SM 2 PIM-SM 3
Loop0
Loop0
Source 1
Source 2
Receiver
Host B
Receiver
Host C
Receiver
Host A
Vlan-int100
Vlan-int200
Switch A
Switch C
Switch D
Switch B
V
l
a
n
-
i
n
t
1
0
3
V
l
a
n
-
i
n
t
1
0
3
V
l
a
n
-i
n
t
1
0
1
V
l
a
n
-
i
n
t
1
0
1
Vlan-int300
Vlan-int104
Vlan-int104
Vlan-int500
Vlan-int400