51
A multicast user control policy is configured on Switch B so that Host A can join or leave only multicast
g ro u p 224 .1.1.1.
Figure 18 Network diagram
Configuration procedures
1. Configure an IP address and subnet mask for each interface as per Figure 18. (Details not shown.)
2. Configure Switch A:
# Create VLAN 101 through VLAN 104 and assign GigabitEthernet 1/0/1 through
GigabitEthernet 1/0/4 to the four VLANs respectively.
<SwitchA> system-view
[SwitchA] vlan 101
[SwitchA-vlan101] port gigabitethernet 1/0/1
[SwitchA-vlan101] quit
[SwitchA] vlan 102
[SwitchA-vlan102] port gigabitethernet 1/0/2
[SwitchA-vlan102] quit
[SwitchA] vlan 103
[SwitchA-vlan103] port gigabitethernet 1/0/3
[SwitchA-vlan103] quit
[SwitchA] vlan 104
[SwitchA-vlan104] port gigabitethernet 1/0/4
[SwitchA-vlan104] quit
# Enable IP multicast routing. Enable PIM-DM on VLAN-interface 101, VLAN-interface 102 and
VLAN-interface 104, and enable IGMP on VLAN-interface 104.
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim dm
[SwitchA-Vlan-interface101] quit
[SwitchA] interface vlan-interface 102
To Next Page
Loading...
