H3C S7500E Series Installation Manual

65
Figure 47 Use the LC optical fiber connector to connect the pluggable interface modules
LC plug
SFP module
IMPORTANT:
• When the switch is connected to the network, you can use the ping or tracert command check the
connectivity between the switch and the network. For more information about the two commands, see
the H3C S7500E Series Ethernet Switches Command Reference .
• For more information about the optical fibers, see the chapter “Appendix D Cables.”

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English