62
Table 17 Basic access function configurations
Function Description
IP addresses Allows you to remotely manage the switch and use the switch in a network.
Static routing Allows the switch to implement routing.
VLAN Divides the network into multiple VLANs, and improves data security.
MSTP Avoids loops in a network using dual uplinks to provide redundancy.
Configuration example
Configuring the Telnet login
# Enter system view.
<Sysname> system-view
# Enter user interface view of VTY 0.
[Sysname] user-interface vty 0
# Configure the authentication mode as password for users logging in through user interface VTY 0.
[Sysname-ui-vty0] authentication-mode password
# Configure the password as hello for users logging in through user interface VTY 0.
[Sysname-ui-vty0] set authentication password cipher hello
# Set the user privilege level to 3 for the users that log in through user interface VTY 0. Then, all users that
log in through Telnet can use all commands.
[Sysname-ui-vty0] user privilege level 3
[Sysname-ui-vty0] quit
Configuring the basic access function
• Configure IP addresses.
# Create VLAN-interface 1.
[Sysname] interface vlan-interface 1
# Assign an IP address to VLAN-interface 1 according to the IP network segment distribution and usage
in the current network. 192.168.0.1 is used as an example.
[Sysname-Vlan-interface1] ip address 192.168.0.1 24
[Sysname-Vlan-interface1] quit
• Configure static routes
# Configure a static route, with the destination IP address 172.16.1.0 and the next hop IP address
192.168.0.2.
[Sysname] ip route-static 172.16.1.0 255.255.255.0 192.168.0.2
• Configure VLANs
# Create VLAN 10, and enter its view.
[Sysname] vlan 10
[Sysname-vlan10]
# Assign port GigabitEthernet 2/0/1 to VLAN 10.
[Sysname-vlan10] port gigabitethernet 2/0/1
[Sysname-vlan10] quit
To Next Page
Loading...
Need help?
General
