Hammer B3 - Page 5

5
Saw-Spindle Moulder
B3 / B3 e-classic
Table of Contents
9.7.2 Mounting/removing/changing the spindle moulder tool ................................................................61
9.7.3 Prepare the machine to operate ..................................................................................................62
9.8 Establishing/setting the speed/Set .................................................................................63
9.8.1 Establishing/setting the speed ....................................................................................................63
9.8.2 Maximum spindle resiliance (rotation limit) ...................................................................................64
9.8.3 Adjusting the moulder spindle rotation .........................................................................................65
9.8.4 Sink the spindle moulder ...........................................................................................................66
10 Operation Saw unit .................................................................................................67
10.1 Safety instructions ......................................................................................................67
10.2 Switching on the machine / Switching off the machine / Emergency-stop ..........................68
10.3 Moving the sliding table ..............................................................................................69
10.4 Working techniques ....................................................................................................69
10.4.1 Work stations .........................................................................................................................69
10.5 Working techniques ....................................................................................................70
10.5.1 Permitted working techniques ...................................................................................................70
10.5.2 Prohibited working techniques ..................................................................................................70
10.5.3 General procedures for authorised working techniques ................................................................70
10.5.4 Longitudinal cut ......................................................................................................................71
10.5.5 Trimming ...............................................................................................................................71
10.5.6 Cutting wedges ......................................................................................................................72
10.5.7 Cutting with an outrigger .........................................................................................................73
10.5.8 Cutting with the crosscut fence .................................................................................................73
10.5.9 Groove cuts ...........................................................................................................................74
10.5.10 Working with grooving tools ..................................................................................................75
11 Operation - Spindle moulder unit .............................................................................76
11.1 Safety instructions ......................................................................................................76
11.2 Switching on the machine / Switching off the machine / Emergency-stop ..........................77
11.3 Working techniques ....................................................................................................78
11.3.1 Work stations .........................................................................................................................78
11.3.2 Authorised working techniques .................................................................................................78
11.3.3 Prohibited working techniques ..................................................................................................78
11.3.4 General procedures for authorised working techniques ................................................................79
11.3.5 Moulding long sides and profiles ..............................................................................................79
11.3.6 Slot and tenon moulding .........................................................................................................80
11.3.7 Insert moulding ......................................................................................................................80
11.3.8 Curve moulding .....................................................................................................................81
11.3.9 Moulding with a power feeder .................................................................................................82
11.3.10 Moulding with a high velocity spindle .....................................................................................82
12 Maintenance ...........................................................................................................83
12.1 Safety instructions ......................................................................................................83
12.2 Maintenance schedule ................................................................................................83
12.3 Cleaning the bearing tracks .........................................................................................84
12.4 Lubricating the height and tilting spindles ......................................................................84
12.5 Tightening/replacing the drive belt ...............................................................................85
12.5.1 Retensioning the drive belt .......................................................................................................85
12.5.2 Replacing the drive belt ...........................................................................................................85
12.6 Checking the scoring belt ............................................................................................86
12.7 Cleaning/changing the dust brush of the outrigger arm ..................................................86
12.8 Renewing the sliding table scraper blade (ball cage) ......................................................87
12.9 Disassembling the sliding table ....................................................................................87
12.10 Assembling the sliding table ......................................................................................88
12.11 Lubricating the spindle moulder socket and tilting segments ...........................................89