5 - Operation
91
Settings driving mode
⢠Press on button to scroll the messages:
Field / Uphill / Downhill mode
The machine has 3 modes used in the field, according to the constraints of work related to the terrain (flat ground, up or
down) to optimize the power of hydraulic motors
In field, uphill, downhill modes, the engine speed remains constant and does not depend of the position of forward grip
Field mode is typically used on flat ground or in small slopes. In this case the front and rear hydraulic motors are in full
displacement. However, if the travel speed exceed 15 kph, the front hydraulic motors run on half displacement (Up-shift),
thus increasing the maximum travel speed of the machine.
In Uphill mode, the front hydraulic motors are in half displacement and the rear hydraulic motors are in full displacement.
In downhill mode, the front hydraulic motors are in full displacement and the rear hydraulic motors are in half
displacement.
±
ATTENTION! Field, Uphill, Downhill mode require a minimum engine speed of 1500 r.p.m. for the transmission to give
enough traction and braking torque
Change from Road mode to Field, Uphill, downhill
1. Place the grip in neutral position.
2. Turn the speed selector on one of the 3 positions.
3. Increase the speed engine to a minimum of 1500 r.p.m
4. Push the grip towards to achieved the required the travel
speed.
Speed limitation in «Field» mode, «Uphill»,
«Downhill»
Speed limitation in «Road» mode,
Engine RPM limitation Electronic Traction Control (SAPE) disengaged
Drive mode «NORMAL» Electronic Traction Control (SAPE) engaged
Drive mode «POWER» Drive mode «COMFORT»
«Field» mode engaged «Uphill» engaged «Downhill» engaged