6 - Maintenance
149
• Run engine up to operating temperature (opening temperature of the thermostat) allow to bleed the coolant circuit
• Switch off the engine.
• Check coolant level in cooled engine and top up to the MAX mark or filling level on the expansion tank if necessary.
÷
NOTE! The excess of coolant is automatically eliminated through the outlet pipe
÷
NOTE! Never mix with other coolants. If in doubt, drain the cooling circuit completely.
Only use the recommended coolant. See “Suitable Lubricants” page 141.
Battery
The battery does not require any special maintenance. It has optimum starting power even in low temperatures or intense
heat.
±
WARNING! The electrical and electronic equipment requires a battery in good working order. A damaged battery
could cause damage to the electronic equipment.
±
WARNING! Never disconnect the battery when the engine is running.
±
WARNING! Always disconnect the terminals before recharging the battery or performing welding operations.
±
WARNING! To avoid any risk of the battery exploding, it should be recharged in a ventilated area where no smoking
is allowed. Never short circuit the terminals.
±
WARNING! Never reverse the polarity.
To Next Page
Loading...
Need help?
General
