5 - Operation
92
Change between Field, Uphill, downhill mode
The change from one mode to the other Field mode can be achieved while driving
Change from Field, Uphill, downhill to Road mode
1. Turn the speed selector to Road mode, the status appear in
orange.
2. Pull the grip in neutral position, the automotive mode is engaged
when the status become in white.
3. Pull the grip toward or press the pedal, depending the selected
control mode.
Automotive mode
The machine has an automotive mode, it works as well in road mode as in field mode. The Automotive mode simplifies the
driving of the machine, significantly reducing the noise and fuel consumption. The engine speed is proportional to the
position of the grip or the pressure on the throttle pedal, except during the braking phase. In this case the engine speed
depend directly of the hydraulic motors displacement (Half displacement of front and rear motors).
Before use the automotive mode :
• Press on button to select the message «ECO»
• Press the buttons to enable or disable the Road or/and Field
automotive mode
How to use the automotive mode
• Place the grip in neutral position.
• Turn the speed selector in road position (rabbit). The engine is
idling
• Turn the speed selector to the desired position
• Gradually push the grip to achieve the required travelling speed
or
• Move the grip forward or backward according to the direction of
travel of the machine and press the throttle pedal to move the
machine.
Thedisplay shows the control mode in use
Grip control Throttle pedal control
To Next Page
Loading...
Need help?
General
