6 - Maintenance
165
Occasional Maintenance
General Info
The maintenance and service intervals for the following components will depend very much on the conditions under which
the sprayer is operated, and therefore it is almost impossible to specify the intervals beforehand.
The operator must select appropriate intervals for the occasional maintenance.
If in doubt, contact your local HARDI dealer.
Lifting and Removing the Pump
When lifting and removing the pump, use a shackle fitted to the built-in
lifting eye located between the heads (A).
±
WARNING! To prevent damages in case of a free-falling pump, use
lifting gear and a steel shackle with at least 3.5 tonnes max. tensile
strength.
NOTE! Pump weight is approximately 75 kg
Pump Valves and Diaphragms Renewal
Pump mode: 464
1. ift off the plastic covers with your hands (A) by pulling with the
finger tips while pushing with the thumbs in the centre, as shown
in (B).
To Next Page
Loading...
Need help?
General
