6 - Maintenance
188
After Storage
1. After a storage period, the sprayer should be prepared for the next season the following way:
2. Adjust the tyre pressure
3. Wipe off the grease from hydraulic ram piston rods.
4. Fit the pressure gauges again. Seal with Teflon tape or similar.
5. Antifreeze is drained from the tank and spray boom.
6. Fill with clean water and check all functions. Liquid test: Fill a small amount of water in the tank and circulate it around
the liquid system. Spray pressure = 5 bar. Repair leaks if any. Check spray patterns.
7. Rinse the entire liquid circuit of the sprayer with clean water.
8. Check that the main tank is clean inside and close the drain valve.
9. Traffic lights are visible and in good working order. The protection glasses are clean and without damages.
10. Check all electric functions.
11. Check that the spray boom folds correctly - make adjustments if needed. Repair oil leaks if any. Check that hydraulic
hoses and electric cables are in place, and that they and follow the folding movements without being damaged.
12. Sensors are in good condition and free of dirt.
To Next Page
Loading...
Need help?
General
