GigE Area Scan Camera User Manual
13
3. Set NIC property via the PC.
1) Go to NIC settings page: Control Panel → Hardware and Sound → Device Manager
→ Network Adapter.
2) Select corresponding network interface card, and click Advanced.
3) Set Jumbo Packet value to 9014 Bytes, Transmit Buffers and Receive Buffers to 2048,
Interrupt Moderation Rate to Extremum.
4. (Optional) Set NIC property via the MVS.
1) Right click the GigE, and click NIC Settings.
Figure 5-5 Click NIC Settings
2) Enable Jumbo Frame, and set Receive Buffers and Transmit Buffers to 2048.
Figure 5-6 NIC Configurator
Note
The max. value of receive buffers and transmit buffers may differ by network interface
cards.
To Next Page
Loading...
