HIKVISION DS-2SE4C425MWG-E/26(F0) - Page 62

6.
Click Save.
Set Encrypted Memory Card
Before You Start
●
Insert an encrypted memory card to the device. For detailed installaon, refer to Quick Start
Guide of the device.
●
You need to know the correct encrypon password of the memory card.
Steps
1.
Go to Conguraon → Storage → Storage Management → HDD Management .
2.
Select the memory card.
Note
If an Unlock
buon appears, you need to unlock the memory card rst. See
Detect Memory
Card Status f
or details.
3.
V
erify the encrypon password.
1) Click Parity.
2) Enter the encrypon password.
3) Click OK.
When the Encrypon Status turns t
o Encrypted, the memory card is ready for use.
Note
If the
encrypon password is forgoen and you sll want to use this memory card, see
Set New
or Unencrypted Memory Card t
o format and set the memory card. All exisng contents will be
removed.
4.
Oponal: Dene the Quot
a of the memory card. Input the percentage for storing dierent
contents according to your needs.
5.
Click Save.
Detect Memory Card Status
The device detects the status of Hikvision memory card. You receive nocaons when your
memor
y card is detected abnormal.
Before You Start
The conguraon page only appears when a Hikvision memory card is installed to the device.
Steps
1.
Go to Conguraon → St
orage → Storage Management → Memory Card Detecon .
2.
Click Status Detecon to check the Remaining Lifespan and Health Status of your memory card.
Remaining Lifespan
TandemVu PTZ Camera User Manual
50