Hitachi Compute Blade 500 Series - Page 141

Menu items
Selection
1
Description
POST Fail Retry • Disable
• <<Enable>>
Enable or Disable POST Fail Retry. POST
Retry is performed automatically when
EFI firmware detects any memory failure
at POST.
Notes:
1. A value in double angle brackets, << >>, shows the default.
2
. These items are displayed but are not available.
Security sub menu
Place the cursor on a menu to set, and press Enter.
The following table shows description of menu items displayed in the left side
of the window.
Select a menu to set, and press Enter.
Table 2-107 Security sub menu items
Menu items Selection Description
Secure Boot Configuration - Sets the secure boot configuration.
Trusted Platform Module
(TPM 1.2)
- Displays TPM option setting window. See
Trusted Platform Module (TPM 1.2) on page
2-121 for details.
Trusted Platform Module (TPM 1.2)
Place the cursor on an item to set, and press Enter.
Note: Do not change the settings of the following item. If you change the
settings in a poor attempt, UEFI may not start up.
•
MOR State
The following table shows description of menu items displayed in the left side
of the window.
Select an item to display or set, and press Enter.
Table 2-108 System Security sub menu items
Menu items
Selection
1
Description
TPM Status
TPM Physical Presence - Displays the status of TPM Physical
Presence.
TPM Device State - Displays TPM Device State.
UEFI setup menu
2-121
Hitachi Compute Blade 500 Series EFI User's Guide