Hitachi Compute Blade 500 Series - Page 177

4. Click a disk in Drives
pane for building disk array.
Select a hard disk in Drives
pane when building a disk array with hard
disk on status of "Unconfigured Good" (unused).
Go to step 7 without selecting a hard disk when adding disk array to the
existing drive group.
The number of disks required varies depending on the RAID level to be
set. The following table summarizes the number of disks required.
MegaRAID WebBIOS for LSI SAS 2008
3-27
Hitachi Compute Blade 500 Series EFI User's Guide