Hitachi Compute Blade 500 Series - Page 97

Table 2-67 System Settings menu items
Menu items Description
Adaptors and UEFI
Drivers
Displays information about adapters and UEFI drivers on the
server blade.
Processors Displays and provides option to change the processor settings.
See
Processors sub menu on page 2-77.
Memory Displays and provides option to change the memory settings.
See Memory sub menu on page 2-78.
Devices and I/O Ports Displays devices and I/O port options of settings.
Operating Modes Selects the operating mode desired based on your preference.
Legacy Support Selects the legacy support.
System Security Selects the TPM setup options.
See System Security sub menu on page 2-80.
RAS Configuration Sets RAS configuration.
See RAS Configuration sub menu on page 2-81.
Storage Selects this option to see all the Storage Device options.
Network Selects the Network setup options
Processors sub menu
Select an item to display or set, and press Enter.
The following table shows description of menu items appeared in the left side
of the window.
Select an item to display or set, and press Enter.
Table 2-68 Processors menu items
Menu items
Selection
1
Description
Turbo Mode • Disable
• <<Enable>>
Sets a CPU Turbo Mode, which is
enabled after the reboot.
Shown only when supported by
installed CPUs.
Processor
Performance States
•
Disable
• <<Enable>>
Sets CPU EIST, which is enabled
after the reboot.
C-States • Disable
• <<Enable>>
Sets a CPU power saving mode,
which is enabled after the reboot.
Package ACPI C-
State Limit
• ACPI C2
• <<ACPI C3>>
Sets a C-State upper limit during
the CPU idle mode.
C1 Enhanced Mode • Disable
• <<Enable>>
Sets CPU Enhanced C1E State,
which is enabled after the reboot.
UEFI setup menu
2-77
Hitachi Compute Blade 500 Series EFI User's Guide