Honeywell Farenhyt Series Manual

Cut along dotted line.
Model IFP-300ECS Basic Operating Instructions
These Instructions must be framed and displayed next to the IFP-2100ECS panel in accordance with NFPA 72
fire code for Local Protected Fire Alarm Systems. Test the system in accordance to NFPA 72.
P/N LS10163-001SK-E Rev B ECN: 151770
Operation Task to Perform
Silence Alarms and Troubles Press SILENCE and then enter a code if prompted. The Silence LED will light.
Reset Alarms
1. Press RESET and then enter a code if prompted.
2. Press 1 to reset the Fire System or 2 to reset the Emergency Communication
System.
To reset the ECS at an LOC, the user must gain ECS Control (See Figure 1).
View all active alarm, trouble,
and supervisory signals
The highest priority event will display first. Press the Down arrow to view location and
type of alarm or trouble.
View Point Status
1. Login to the panel.
2. Press 2 to select Point Functions.
3. Press 2 to select Point Status.
4. Select the desired module by using the Up or Down button. Then press ENTER.
5. Enter the point number.
Conduct a Fire Drill
Hold the DRILL button and then enter a code if prompted. OR
1. Login to the panel.
2. Then Press 1 to select System Tests.
3. Press 1 to select Fire Drill.
4. Press ENTER to start the fire drill. Press ENTER to end the fire drill.
Set Time and Date
1. Login to the panel.
2. Press 4 to select Set Time & Date.
3. Make changes in the fields on the screen as necessary.
4. When the time and date are correct, press ENTER.
Enable / Disable a Point
1. Login to the panel.
2. Press 2 to select Point Functions.
3. Press 1 for Disable / Enable Pt
4. Press 7 for Disable / Enable Pt.
5. Use the Up or Down button to move through the list. Then press ENTER to select
the module where the desired point is located.
6. Enter the point or circuit number that you want to disable/enable.
7. Press the right arrow key to toggle between NORMAL (enable) or DISABLE.
To Gain / Request ECS Control
Press the ECS Control Button and follow the on-screen Instructions.
When the ECS Control LED is blinking, another LOC has ECS Control. The ECS
Control LED is on steady when the LOC has ECS Control.
For Service Call:
FIRE: ALARM SUPERVISORY TROUBLE
CO: ALARM SUPERVISORY
EMERGENCY: ALARM SUPERVISORY
SYSTEM: TROUBLE

Honeywell Farenhyt Series Specifications

General

Brand	Honeywell
Model	Farenhyt Series
Category	Control Panel
Language	English