Honeywell HRGX45 User Manual

www.honeywell.com/security
102 | HRGX DVR User Manual
Configuring General Network Settings
This section describes how to configure your DVR’s general network settings. Your network
settings must be properly configured before you operate the DVR over a network.
To configure general network settings:
1. Go to Menu > Settings > Network > General.
2. Configure the following settings:
3. Click Apply to save your settings.
•NIC Type Select your network interface controller type from the list.
•Enable DHCP DHCP is enabled by default. To disable it, clear the check box.
•IPv4/IPv6 and DNS If DHCP is disabled, manually enter your DVR’s network settings.
•MTU(Bytes) Select a value between 500 and 1500 . Default setting is 1500 .
• Bandwidth Throttle Select a value between 1Mbps and 30Mbps or select None .
•Server Port Used for remote client software access. Default setting is 8000 .
• HTTP Port Used for remote browser access. Default setting is 8001 .
•RTSP Port Used for multimedia playback. Default setting is 554 .

Honeywell HRGX45 Specifications

General

Brand	Honeywell
Model	HRGX45
Category	DVR
Language	English