Recording Video | 63
800-16694 - A - 04/2014
Configuring Redundant Recording
If you have two or more HDDs, with the HDD storage mode set to Group (see Configuring HDD
Groups, page 117), you can enable redundant recording—that is, you can set up the DVR to
save recorded video not only on the R/W (read/write) HDD but also on the redundant HDD for
additional security and reliability.
To configure redundant recording:
1. Go to Menu > HDD > General.
2. Under HDD Information, select the HDD you want to configure as the redundant HDD,
and then click the Edit button to open the Local HDD Settings window.
3. Click Read-only, click Apply to save the setting, and then click OK.
4. Go to Menu > Record > Encoding > Record.
5. In the Camera list, select the camera you want to record to both the R/W and Read-only
HDDs.
6. Select the Redundant Record check box.
7. To copy these settings to one or more additional cameras, click Copy to open the Copy to
window, select the camera(s) you want to copy the settings to, or click Analog to copy the
settings to all cameras, and then click OK.
8. Click Apply to save your settings.
To Next Page
Loading...
Need help?
General