Introduction | 21
800-16694 - A - 04/2014
Pairing the Remote Control with the DVR
To pair the remote control with the DVR, follow these steps:
1. Turn on the DVR.
2. Using the mouse, log in to the DVR.
3. Right-click anywhere on the screen to display the shortcut menu, and then click Menu.
4. If prompted, enter the DVR’s admin password. The default admin password is 12345.
5. In the main menu, click Settings.
6. In System Settings, on the General page, click the More Settings tab.
7. Make a note of the device number of the DVR. The default device number is 255.
8. Press the DEV button on the remote control, input the device number, and then press the
ENTER button.
Troubleshooting the Remote Control
If there is no response when you try to use the remote control, follow these steps:
1. Check that the batteries are properly installed. Ensure that the polarities are not reversed.
2. Check that the IR receiver on the DVR front panel is not obstructed.
3. Aim the remote control at the IR receiver.
If the problem persists, contact your Honeywell dealer for a replacement.
To Next Page
Loading...
Need help?
General