Honeywell PC45 Series User Manual

98 PC45 Series Printer User Guide
SNMP
To view these settings:
• From the printer Main Menu, select Settings> Network Services > SNMP.
• From the printer web page, click Configure > Network Services > SNMP.
SNMP Description Default
Authentication Failure
Trap
Determines if the printer sends a trap to its management
station when a request is received from an unauthorized
source.
Disable
Read Community Sets the name of the community that has rights to read the
SNMP MIBs.
-
Write Community Sets the name of the community that has rights to write the
SNMP MIBs. Range is 1 to 32 characters.
-
SNMvP1 Determines if the printer supports SNMvP1 functionality. Enable
SNMvP2 Determines if the printer supports SNMvP2 functionality. Enable
Trap Status 1 - 4 Determines if the trap is enabled or disabled Enable
Trap Name1 -4 Sets a descriptive name for the trap. -
Trap Address 1 -4 Sets the IP address of this trap. 0.0.0.0
Trap Port Number 1-4 Sets the port number of this Trap address. Range 1 to 65535. 162
Trap Community 1 - 4 Sets the name of the trap community. Range 1 to 32
characters
Public
SNMPv3 Username Sets the username that the printer uses when
communicating with its management station. Range is 1 to
32 characters.
-
SNMPv3
Authentication Key
Sets the password that is used to generate a key that verifies
that the printer is authorized to communicate with the
management station. Range is 8 to 32 characters.
-
SNMPv3 Encryption
Key
Sets the password that is used to generate a privacy key that
is used for encryption. Range is 8 to 32 characters.
-
SNMPv3
Authentication
Protocol
Selects the algorithm that the printer uses to determine that
the messages are from valid source.
SHA
SNMPv3 Encryption
Protocol
Selects the type of encryption that the printer uses to prevent
messages from being seen by an unauthorized user.
AES

Honeywell PC45 Series Specifications

General

Brand	Honeywell
Model	PC45 Series
Category	Printer
Language	English