PC45 Series Printer User Guide 69
About Disinfectant Ready Models
Some configurations of the PC45 series printers are available with external plastic
housings that are designed to resist the effects of harsh chemicals. These specialty
printer configurations are equipped with disinfectant-ready housings (DRH) for
healthcare and/or general-purpose markets.
Please refer to the Honeywell Safety and Productivity Solutions website for specific
details on how to clean the PC45 series model with disinfectant-ready housings.
Helpful information on the care of these specialty products can be found in the fol-
lowing articles:
• Learn to Clean Honeywell Healthcare Disinfectant-Ready Products
• Honeywell Instructions for Cleaning General Purpose Disinfectant-Ready
Housing Devices
• Disinfectant-Ready Housing Application Brief
Replace the Printhead
You need to replace the printhead periodically when it wears out due to the rapid
heating and cooling process used during printing. How often you need to replace
the printhead depends on factors such as what type of images you print, the type
of media or ribbon you use, the amount of energy to the printhead, the print speed,
and the ambient temperature of the room you print in. The firmware detects the
new printhead when you restart the printer.
1. Turn the printer off and disconnect the printer from power.
2. Pull one or both of the printer latches toward the front of the printer and lift the
printer lid.
3. Remove the media and ribbon (if installed).
4. Press the printhead latches apart until the peripheral slides forward.
To Next Page
Loading...
Need help?
General
