PC45 Series Printer User Guide 81
DEFAULT SETTINGS
Use this appendix to view the printer’s factory default settings.
Communications
Serial Port
The printer must be connected to the PC through a serial port to view the settings:
• From the printer Main Menu, select Settings > Communications > Serial >
COM1.
• From the printer web page, click Configure > Communications > Serial.
Serial Port
Setting
Description Default
Baud Rate Transmission speed in bits per second (bps) for the serial
port.
115200
Data Bits Number of bits that define a character or byte. 8
Parity Specifies how the printer checks the integrity of the
transmitted data.
None
Stop Bits Number of bits sent at the end of every character to allow the
receiving signal hardware to detect the end of a character
and to resynchronize with the character stream.
1
Hardware Specifies if hardware flow control (RTS/CTS) is used to
manage the rate of data transmission between the device
and the host.
Disable
ENQ/ACK Specifies if software flow control (ENQ/ACK) is used to
manage the rate of data transmission between the device
and the host.
Disable
XON/XOFF To Specifies if software flow control (XON/XOFF) is used to
manage the rate of data transmission to the host.
Disable
XON/XOFF From Specifies if software flow control (XON/XOFF) is used to
manage the rate of data transmission from the host.
Disable
New Line Character Defines the characters that the printer echoes to the host to
indicate that it has moved to a new line.
CR/LF
To Next Page
Loading...
Need help?
General
