82 PC45 Series Printer User Guide
Ethernet
To view these settings:
• From the printer Main Menu, select Settings > Communications > Ethernet.
• From the printer web page, click Configure > Communications > Ethernet.
Ethernet Setting Description Default
(IPv4) IP Assignment
Method
Specifies how the printer obtains an IP address. DHCP
(IPv4) IP Address Specifies the unique network-level address that is
assigned to each device in a TCP/IP network (IPv4).
0.0.0.0
Subnet Mask Specifies a number that defines the range of IP addresses
that can be used in a TCP/IP network.
0.0.0.0
Default Router Specifies the IP address of a router that is used when a
device sends a packet to another subnet or to an
unknown destination.
0.0.0.0
DHCP Response Specifies if the printer receives DHCP responses by
broadcast or unicast.
Broadcast
(IPv6) IP Assignment
Method
Specifies how the printer obtains an IP address (for IPv6
networks).
Automatic
(IPv6) IP Address Specifies the unique network-level address that is
assigned to each device in a TCP/IP network (IPv6).
Automatic
802.1xSecurity Enables 802.1x security Disable
EAP Type Selects the protocol that the radio uses to verify its
identity and makes sure that it is authorized to
communicate on the wireless network.
PEAP
Username Specify Username for 802.1x Authentication -
Password Password for PEAP authentication or private-key
password for TLS
-
CA Certificate Sets the name of the Certificate Authority (CA) that
verifies the server certificate. This CA should be the same
one that was used to sign the server certificate.
-
Client Certificate Sets the name of the client certificate the printer uses to
authenticate to the network using EAP-TLS. Maximum
length is 128 characters.
-
Private Key Sets the full path to the private key file the printer uses for
EAP-TLS. Maximum length is 128 characters. If using pfx
file here, the Client Certificate should not be specified.
-
To Next Page
Loading...
Need help?
General
