EasyManuals Logo

Honeywell Vibrex 2000 User Manual

Honeywell Vibrex 2000
288 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #105 background imageLoading...
Page #105 background image
Chapter 5 General Operation
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
89
5.2.1 Powering Up
To turn on the Vibrex unit, press the ON/OFF button. To turn off
the unit press the ON/OFF button again. The unit has the
following powering on- and-off features:
To keep the user from powering down the unit
unintentionally, the user must hold down the ON/OFF button
for at least 1 sec. while the unit is in operation.
If there are no key presses or activity on the balancer for 10
min., the unit enters a “rest” mode to keep the batteries fresh.
To restart the unit at any time, press the ON/OFF button
again.
NOTE: All Vibrex 2000 units come shipped with batteries.
If the batteries run low or lose power, the Vibrex unit may
not power up. However, the user does not lose data stored
in the memory during this time. The unit keeps data in its
memory for up to 8 hr. without batteries and/or power.
5.2.2 Main Menu Screen
The Main Menu screen is slightly different for the Vibrex
2000/Vibrex 2000 Plus and the Enhanced Vibrex 2000 Plus.
Vibrex 2000 and Vibrex 2000 Plus
Directly after the Vibrex 2000 or Vibrex 2000 Plus powers up,
the Self- test screen displays (telling the user the unit is testing
itself), then the Main Menu screen. The illustration below shows
the Main menu.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell Vibrex 2000 and is the answer not in the manual?

Honeywell Vibrex 2000 Specifications

General IconGeneral
BrandHoneywell
ModelVibrex 2000
CategoryTest Equipment
LanguageEnglish

Related product manuals