Chapter 5 – General Operation
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
128
The RPM of the balance measurement displays in the
lower left corner of the screen.
The RPM of the balance run displays in the lower left
corner of the balance reading.
A day/date code also displays. See Section 5.4.5.1
“Reviewing Propeller Balance Measurements”.
2. The user may go directly to another run by pressing the
NEXT RUN or PREV RUN context key.
3. The user may skip to any measurement stored by pressing
the MEASUREMENTS context key and entering the run
number the user wants to view.
5.4.5.3
Reviewing Spectrum Peak
Measurements
Review spectrum peak measurements, as follows:
1. From the Review Menu screen press the PEAK LISTS
context key. The measurements display, as follows:
The list number displays in the upper right corner of the
screen.
The annotation displays at the bottom of the screen.
The RPM range of the measurement displays above the
annotation.
A day/date code also displays. See Section 5.4.5.1
“Reviewing Propeller Balance Measurements”.
2. The user may go directly to another spectrum by pressing
either the NEXT LIST or PREV LIST context key.
NOTE: For more information on the Vibrex unit’s
Spectrum Analysis feature, see Section 5.6 “Spectrum
Analysis”.
To Next Page
Loading...
Need help?
General
