Honeywell Vibrex 2000 User Manual

Chapter 3 – Getting Started
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
37
3.3.1.1 Basic Settings
See the following table for a list of the basic settings to use for
downloading data from the Vibrex 2000 or Vibrex 2000 Plus to
any printer and/or serial interface.
Parameter
Setting
Baud rate
9600
Number of bits
8
Number of stop bits
1
Parity
None
Xon/Xoff
Supported
3.3.1.2 Connecting the Printer
Connect a Seiko Model DPU-414 printer to the Vibrex 2000 or
Vibrex 2000 Plus, as follows:
1. Connect the printer cable No. 610-449 to the Vibrex unit and
the printer.
2. Turn ON the printer and press the ONLINE button if the on-
line light- emitting diode (LED) is not illuminated.
3. Select the desired information to be printed in the Vibrex
unit and press PRINT.
NOTE: If the batteries are depleted in the DPU-414,
connect the ac wall adapter (No. 610-463 for 110 Vac or
No. 610-463A for 220 Vac) and operate the printer
normally.

Honeywell Vibrex 2000 Specifications

General

Brand	Honeywell
Model	Vibrex 2000
Category	Test Equipment
Language	English