Honeywell Vibrex 2000 User Manual

Chapter 5 – General Operation
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
185
changes will be lost.
5.6.6 Helicopter Balance Run Print,
Review and Clearing
Press the PRINT hard key to print the runs. Printing is as
described in 3.3.2, “Printing With a PC”. The PRINT key is
active at only at certain points within the Helicopter Balance
menus where it makes sense to print.
HELPFUL HINT 1: Printing multiple runs is easier with
the “global print” option from the main menu. Use the
following shortcut:
 Press the SPACE hard key anytime you are not editing
a field.
 Press the PRINT hard key – you will be taken to the
global print menu.
HELPFUL HINT 2: To print a single run, press REVIEW
hard key, navigate to the proper run, then press the PRINT
hard key.
Press the REVIEW hard key to review the current or previous
runs on the screen. If you are using a “global review” from the
main menu, you will also be allowed to clear out previous runs.
The CLEAR key can only be used to clear all runs and not
individual runs.
Each helicopter run consists of a lot of information: Job and run
number, aircraft model, component, measurements, adjustments,
options, etc. This is difficult to fit on the small Vibrex 2000
screens – if you have a choice, it is preferable to print these runs.
This first review screen is shown below:

Honeywell Vibrex 2000 Specifications

General

Brand	Honeywell
Model	Vibrex 2000
Category	Test Equipment
Language	English