Chapter 5 – General Operation
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
180
Or you can toggle the job options by pressing the
<CONTINUE JOB> context key, then pressing START to
perform that action. The available actions are: <CONTINUE
JOB>, <BALANCE JOB DONE>, and <CLOSE ALL
JOBS>.
Press the START NEW JOB context key to start a balance
job on a new component for the same model (aircraft). A
menu will appear allowing you to START NEW
COMPONENT or CHG AIRCRAFT MODEL.
CAUTION: You may only select a new component for the
current aircraft model. If you select a new aircraft model
all jobs for the current aircraft will be lost. A prompt on the
screen will warn you of this condition.
NOTE: The EV2K+ only allows for four concurrent
helicopter jobs. The START A NEW BALANCE JOB
context key will not appear if four jobs are already in
progress.
IMPLEMENTATION NOTE: Unlike Propeller Balance
jobs which can be named with a user-edited aircraft ID,
Helicopter Balance jobs are always named by the
component in use for a particular helicopter model. The
component cannot be renamed by the user.
5.6.5 Removing and Editing Models
and Charts
All Enhanced Vibrex 2000 Plus helicopter models and balancing
charts are derived from factory configurations stored within the
unit. Each user may select up to ten of these factory
configurations for his or her user inventory. Once selected, these
configurations may be used “as is” or edited for individual
circumstances. Or they may be removed from the user list.
To Next Page
Loading...
Need help?
General
