Chapter 5 – General Operation
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
123
4. Press the PERMANENT WEIGHT context key and enter the
permanent weight radius, using the numeric keypad.
5. Press START when both values are correct.
The resulting solution displays the weight required at a single
balance point at the permanent radius.
5.4.4.1
If Unable To Use Weight Azimuth
The user may not be able to use the azimuth of the balance
weight, for clearance or other reasons, or the weight may be too
much for a single-weight addition point. In these cases, do the
following procedures:
1. Press the context key labeled AT [XX:XX].
2. Press the SPLIT WEIGHT context key.
3. Enter the angle or angles available for weight addition.
CAUTION: The user must enter two weight points one on
either side of the single-weight location in order for the
solution to result in the same IPS reading.
The Vibrex unit calculates the required weight on each point.
NOTE: As the weight is split farther apart, the required
weight becomes greater because of the lower combined
moment arm of the weight from the center of rotation.
4. Do a final run to verify that the user has installed the
permanent weights correctly. Then press DONE. The Vibrex
unit displays the following screen:
To Next Page
Loading...
Need help?
General
