Honeywell Vibrex 2000 - Printing with REVIEW and PRINT Keys

Chapter 3 – Getting Started
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
51
<ALL RUNS> Prints all helicopter FasTrak
®
runs
stored to memory.
Printing Optical Blade Tracker (OBT) Debug Log
(EV2K+ Heli Only) - The OBT Debug log is printed as soon
as the PRINT context key is pressed. This debug log is very
useful if the FasTrak
®
acquisition is erratic or missing track data.
It normally should be sent to a qualified representative for
interpretation.
NOTE: The most common reasons for erratic FasTrak
®
data are
sun angle and worn or unpainted blades. Check the FasTrak
®
and
magnetic pick-up connections if the data is completely missing.
CAUTION: Because of limited memory, this debug log is
overwritten for each FasTrak
®
acquisition. If erratic or missing
readings persist after checking the sun angle or blade condition,
then this log should be printed immediately after the affected
run.
3.3.4.2 Printing With REVIEW and PRINT Keys
Using the REVIEW key, the user may review and select specific
readings or sessions for printing. The user may select any of the
following printing categories:
Prop Runs Select the propeller measurement, rear
measurement, or adjustment to be printed
and press PRINT. Select <CURRENT
RUN> and press START or PRINT.
Spectrum Select the run to be printed and press
PRINT. Select <CURRENT MEAS> then
press START or PRINT. When the user
selects a run to be printed by the REVIEW