Chapter 5 – General Operation
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
127
Run number in the screen’s upper right corner
Annotation in the screen’s lower right corner
Aircraft ID in the screen’s upper left corner
Number to the left of the colon (:) is the job number
(several balance jobs may be stored separately)
NOTE: A day/date code also displays to identify the run
uniquely from any other run. The day/date coding is
performed automatically at the time the reading was taken.
The channel from which the reading was taken displays
immediately after the day/date code.
2. Press the context key labeled <prop meas> to view the
<rear meas> reading, if a rear measurement was taken.
3. Press the context key labeled <rear meas> to view the
propeller balance adjustment.
NOTE: The RPM of the balance run displays in the lower
left corner of the balance reading.
4. The user may go directly to another run by pressing the
NEXT RUN or PREV RUN context key.
5. The user may view the correction for the propeller by
pressing the key labeled <adjustment>, displaying a
screen giving this information.
5.4.5.2
Reviewing Other Balance
Measurements
Review other balance measurements, as follows:
1. From the Review Menu screen press the MEASUREMENTS
context key. The measurements display, as follows:
The measurement number displays in the upper right
corner of the screen.
The annotation displays in the lower right corner of the
screen.
To Next Page
Loading...
Need help?
General
