Chapter 5 – General Operation
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
122
5.4.4 Finishing Propeller Balance
The weights outside on the spinner are not a permanent
installation. The user must move the weights to a permanent
location according to the guidelines found in The Smooth
Propeller Manual (Honeywell).
Continue toward a permanent weight installation, for the Vibrex
2000 and Vibrex 2000 Plus as follows:
1. Press the INSTALL PERMANENTLY context key from the
propeller balance quality screen.
2. If a radius change will occur for the installation of the
permanent weight, press the CURRENT RADIUS context
key.
NOTE: The radius is the number of inches (or any unit)
from the center of rotation. An easy way to determine the
radius is to measure the diameter of the spinner when it is
removed and divide that number by 2.
3. Enter the trial weight radius, using the numeric keypad.
► SELECT ANOTHER JOB
ID: -1
? IMPORTANT! – Were
these changes made?
35.00 gms @ 12:00
► YES, begin next run
NO, GO BACK to edit
To Next Page
Loading...
