Chapter 5 – General Operation
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
164
5.6.2 Helicopter Balancing
A normal balance session is shown in the following menus:
1. Press the main menu Helicopter Balance key. Make sure
the proper helicopter model is selected on the second context
button inside the angle brackets “< >” on the next screen. If
not, press the second context button repeatedly to find the
correct model.
If your model is not in the user list, then press the ADD
AIRCRAFT MODEL key and proceed with the
instructions in paragraph 5.6.1 to add a factory model to
the user list.
Use the EDIT AIRCRAFT MODEL context key to edit
the model name or included balance charts. See
paragraph 5.6.5.
Press the START key when the proper model is selected.
2. Use the following screen to select the balance component,
flight regime and change. Note that the balance measurement
sensor and input channel will be selected on the next screen.
? CHOOSE A/C MODEL
► <A-109EPower >
► ADD AIRCRAFT MODEL
► EDIT AIRCRAFT MODEL
if ok, push START