Chapter 5 – General Operation
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
163
1. Press the HELICOPTER BALANCE context key. If there are
no selected user models the following menu will be shown:
NOTE: This menu may also be entered from the ADD
AIRCRAFT MODEL context key.
Use the and keys find the desired model, then
press the START key to select the desired model. You
can save up to 10 user selected models.
HINT: The model list wraps at the top and bottom. If the
model you are looking for is high on the list, it may be
easier to use the key and go up from the bottom of the
list.
NOTE: A list of available models is shown in Appendix B.
If you do not see your desired model or component, it may
be possible to select a similar model and hand edit the
individual charts to suit the application. If this is not
feasible, contact your representative with the possibility of
adding your model to future releases. The EV2K only
supports main rotors up to 6 blades.
2. Press the START key when you see the correct model. It will
be added to the user list and appear as the default model on
subsequent menus as shown in the next section.
=ADD AIRCRAFT MODEL=
Select from Factory
Configurations
(Used: 0 of 10)
▲ PREVIOUS
<A-109EPower >
▼ NEXT
to add, push START
To Next Page
Loading...
Need help?
General
