Chapter 5 – General Operation
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
100
The Edit Aircraft ID screen displays (see below).
2. From this screen, select the places to be filled by pressing the
CURSOR LEFT or CURSOR RIGHT context key (see the
illustration under step 1).
NOTE: When the user is printing, the aircraft ID entry for the
current aircraft prints out on the hard copy. This ID also labels
data when the user is reviewing propeller balance
measurements.
3. If the user makes a mistake, press the RESTORE/RESET FIELD
context key to start over.
4. After the user has entered the aircraft ID, press START
(dedicated key) to return to the first Propeller Balance Setup
screen.
5. The user may press GO BACK to cancel or undo any edits. This
action also returns the user to the previous screen.
5.4.1.2
Selecting Channels
The Vibrex unit defaults to the following channel assignments:
= EDIT AIRCRAFT ID
==
► CURSOR
LEFT
[
]ENG-[1]
► CURSOR
RIGHT
► RESTORE/RESET
FIELD
if ok, push
START
ENTER THE
AIRCRAFT ID
NUMBER
HERE; THE
DEFAULT IS 1
To Next Page
Loading...
