Chapter 6 – Maintenance
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
224
Note: If Digital balancer is found to be out of Spec’s
contact Honeywell Technical Operations Center.
6.3.6 Clearing Memory Contents
6.3.6.1
Vibrex 2000
There is a global clear of all memory contents invoked by
pressing the zero “0” key during the power up self test.
NOTE: EV2K+ series. A “CLEARNG MEMORY” message
will be briefly displayed and then the unit will shut off.
Power back on again to continue.
Global clear will erase ALL memory contents, including all runs,
spectrums and the fault log. If you are having problems with the
unit, it is advisable to print the fault log PRIOR to erasing it. See
Section 3.3 Print Data.
CAUTION: EV2K+ Series. This series gives you the
ability to modify balance and FasTrak charts and save
chart corrections. Use the global clear option only as a
last resort if you have made modifications. It is highly
recommended to use the global PRINT button and then
select TYPE <AC CHARTS> then PRINT to print out any
chart modifications before clearing.
6.3.7 Complete Unit Disassembly
This section explains how to completely disassemble and
reassemble the Vibrex 2000 and Vibrex 2000 Plus units, under
the following topics:
To Next Page
Loading...
Need help?
General
