Chapter 5 – General Operation
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
188
The Fixed Wing version does not have FasTrak capabilities. Any
references to FasTrak in the Helicopter procedures should be
ignored. The Strobex track functions as it does in the V2K and
V2K+.
5.7.1 Moveline Check
The fixed wing balance Moveline Check feature is a generic
check to test the distance of a balance moveline from a low
power or torque balance point to a high power or torque balance
point. Generally, if the moveline is more than 0.4 IPS, this may
indicate a problem with the propeller or hub. Many times the
propeller blades may be out of track. The EV2K+ Strobex track
feature may be used to check this and track the blades if
necessary.
Caution: Balancing the propeller that does not pass the
moveline check may result in unsatisfactory results.
The Moveline Check menu is shown below.
The check procedure is as follows:
1. Run the prop at its normal low power/torque rating.
Press the TAKE LOW PWR/TORQUE context key.
Select the proper balance channel and press START to
? MOVELINE CHECK RUNx
► TAKE LOW PWR/TORQUE
Low: 0.25 @ 12:00
► TAKE HI PWR/TORQUE
Hi: 0.35 @ 12:00
Moveline= 0.10 IPS-OK
continue, push START
To Next Page
Loading...
Need help?
General
