Chapter 5 – General Operation
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
197
5.8.4.1
After Taking Measurements
After the Vibrex 2000 Plus has taken spectral measurements, it
displays the Spectrum Peaks screen (see Section 5.8.2
“Collecting Spectral Data”), in the same way as the Vibrex 2000.
However, the user may also press the <RPM PEAK IPS> context
key twice to display the Spectrum Viewer screen.
Press this context key to cycle among the following three
spectrum views
(in this order):
Spectrum Peaks
Spectrum Orders
Spectrum Viewer
The illustration below shows an example of the Spectrum
Viewer screen.
To Next Page
Loading...
