Chapter 3 – Getting Started
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
38
Setting DIP Switches - The start-up settings and input method
can be set by the DIP switches (DIP SW). Set the printer’s DIP
switches, as follows:
1. Slide the power switch to OFF.
2. Slide the power switch to ON while pressing the ONLINE
button. Release the ONLINE button after a list of the current
settings starts printing out.
3. The printout of the current settings is followed by the
prompt:
Continue? : Push ‘On-line SW’
Write? : Push ‘Paper feed SW’
To change the DIP SW settings, push the ONLINE
button, and go
to step 4.
To leave the DIP SW settings unchanged, push the
FEED button, and go to step 6.
4. Dip SW1 is printed, prompting the input of new settings
for switch No. 1 through 8 of DIP SW-1.
NOTE: Always input either ON or OFF for every setting in
order for switch No. 1 through 8 because the DIP SW set
mode cannot be canceled once it is initiated.
• ON can be set by pushing the ONLINE button
once and OFF by pushing the FEED button
once.
• The setting is printed out after the ONLINE or
FEED button is pushed to confirm the new
setting.
5. As soon as switch No. 8 is set, the printer once again
prompts with Continue? or Write?, and stops. Repeat
step 3 for DIP SW-2 and -3.
NOTE: The on-line lamp lights when the ONLINE button is
To Next Page
Loading...
Need help?
General
